Dangerous Gas Appliances

Why gas engineers sometimes turn off appliances and attach warning labels...

Firstly, all faults on gas appliances are categotised. There are three defined levels of fault. The highest, most serious level of fault is "Immediately Dangerous" (ID). This means there is a danger to life or property if the appliance is used. This is usually a gas leak, or products of combustion (POC) are entering the property. 

Gas leaks can cause explosions and POCs can cause death by carbon monoxide poisoning. It doesn't matter if the amounts of gas or POC are large or small, or even very very tiny. The law doesn't distinguish. If there is gas or POC where it shouldn't be, that's classified as ID. (There are other faults which can be ID, for example a gas ring burning a worktop or combustible material close by - the danger here is fire, obviously.) 

The second level of fault is called "At Risk" (AR). This means something is wrong, that is, could cause a danger, but isn't actually doing so at the moment. 

The third level covers anything which does not comply with the gas regulations but is neither ID nor AR. This is called "Not to Current Standard" (NCS). 

A good example could be when a gas pipe feeding an appliance is too small. The pressure drop along the pipe means the inlet pressure to the appliance is too low, so the appliance burns less gas than it is designed to burn (the flames are a bit smaller). This is clearly not ID, nor is it even AR, but it isn't right. Provided the appliance is running safely there is no risk, so it is simply classed as "Not to Current Standards" (NCS). 

So what do gas installers do about these three classes of fault?

For NCS faults, the installer simply has a responsibility to inform the gas user, then they can decide whether to do anything about it.

For an "At Risk" or Immediately Dangerous" fault the Gas Safety (Installation and Use) Regulations 1998 require the Registered Gas Installer to correct the fault on the spot, OR impliment a procedure called the "Industry Unsafe Procedure" (IUP), and this is where the reputation mentioned at the beginning stems from.

For an AR fault, unless the fault is going to be rectified immediately, the gas installer is required to:

1) Verbally warn the user that the appliance is "At Risk" and should not be used, and that continued use will be the user's own responsibility. 

2) attach a "DO NOT USE" warning label to the appliance.

3) Issue a written warning notice to the user.

4) Request the user's permission, and turn off the appliance/installation. If permission is refused inform Transco who will contact the customer.

07958 500 900    020 8883 2223   020 3432 4146
               Mobile All Areas                       North London               South London & Surrey