Saniflo Alarm

saniflo-alarm-300x300

Click here to purchase  (£25.99)

For your added security. The Saniflo SaniAlarm will alert you if the water level in your macerator rises to a high level.

This model is suitable for most new or existing Saniflo installations, and is quickly fitted onto the lid of a Saniflo unit.

Note: This Alarm is not suitable for use with Sanicom, Sanicondens, Sanicompact and Sanicubic

Sometimes accidental use, power failures, limescale build up of deposits in very old units (not regularly descaled), can cause a surge of water into the unit.

The alarm then emits a continuous 80 dB warning sound, until it is switched off and the problem is corrected.

The new Saniflo SaniAlarm warns you if the water in the macerator rises to an unusually high level.

SaniAlarm is battery operated and is suitable for most models in Saniflo’s range, including Sanispeed and Sanivite pumps.

A Sanialarm is ideal if your Saniflo is boxed in or hidden behind a wall or cupboard. If you saniflo were to malfunction you would be alerted immediately and this will prevent further problems should they arise.

All you need to install a Saniflo alarm is some good practical skills and a 10mm drill bit, the rest is easy.Easy to install, all you need is a drill with a 10mm drill bit.  

Is your Saniflo boxed, tiled in or behind a wooden panel?

The majority of Saniflo macerators never get descaled from new, after a few years the membrane can be damaged by limescale or the microswitch can become worn if the machine is used a lot. If these two parts have problems the Saniflo will not switch on early enough and the water level in the box can become too high, if a Saniflo alarm was fitted to your macerator pump it would warn you about a potential problem.

The Saniflo alarm is not a diagnostic kit it is simply an alarm which has an air pressure sensor switch which activates when the box has flooded or the water level become too high.

A Saniflo alarm is easy to fit, anyone with basic DIY skills can fit one. All you have to do is drill a 10mm on the Saniflo macerator lid, on the newer Saniflo’s there is a mark to show you where to drill.

Once you have drilled the hole you have to insert a rubber tube which comes with the Saniflo alarm and smear some sealant around the rubber tube insert to make the hole water tight. Once you have done that you simply get the alarm, switch it on and insert the alarm in to the rubber tube and that’s it. 

This model is suitable for most new or existing Saniflo installations, and is quickly fitted onto the lid of a Saniflo unit.

Note: This Alarm is not suitable for use with Sanicom, Sanicondens, Sanicompact and Sanicubic

020 8883 2223   07958 500 900   07773 900 600
SanifloRepairs.co.uk  -  Saniflos.co.uk