Indesit Washing Machines and Washer Dryers

washing machine

• F10 – No cold fill. Check that the taps are on or if the drain hoses are kinked.

• F11 – No hot fill. The ambient temperature is likely to be below freezing possibly due to the pipes being
frozen. Also check that the taps are on or if the drain hoses are kinked.

• F12 – No mixed fill. It is likely that the water is not turned on at the taps.

• F13 – Check the water supply, inlet valve and hot and cold hose connections.

• F14 – A fault with the water heating has occurred.

• F15 – Water is not being pumped out and a flood condition could occur. Check that the drainage hose is raised to the recommended minimum height and that the pipe is not blocked.

• F16 – Extremely high water level Disconnect or turn off the water supply and ensure that the water level does not rise any more.

• F17 – Door not closed properly. Close door firmly at the 3 o’clock position.

• F20/1 – The thermistor resistance has drifted or the temperature scanning sequence is incorrect. The ambient temperature could be below freezing.

• F30/31 – A motor drive problem has occurred. Try running the programme again.

• F40 – Water below protection level during a heat step.

• F41 – Water level detect sequence incorrect.

• F50/51 – Customer language and wash programme have not been saved.
The system will run with default conditions (1000rpm max and English language). 
Book an indesit service engineer to re-programme your product.

07958 500 900  - 020 8883 2223 - 020 3432 4146
      Mobile All Areas                       North London               South London & Surrey